Introduction to the Cask Maturation of Whisky
This article deals with the different casks for the Whisky industry in the heart of Speyside.types, their manufacturing and their after longer use. The photographs were taken at Speyside , which rejuvenates used
whisky) is colourless and clear. Its aroma also hasn't much in common with what we know as whisky. After the final process of maturation begins, which takes the most time compared to the production. In the UK and the rest of Europe, the legal minimum maturation time is three years. But these three years are of course just the beginning for a single malt whisky. The top products of the reach their prime only after 15 to 25 years. During the slow maturation over many years, the tangy aromas of the young whisky become mellower but at the same time more complex.(raw
1. Size of Casks
The casks used in the UK and the US are made from wood. Softwood are unsuited for maturation, since the wood contains resin, which prevents the cask from breathing. The casks must have a capacity of no more than 700 litres; otherwise the would be too weak. There are three basic cask types:
- The first one is the Sherry butt, the port pipe or puncheon. All three have a capacity of 500-700 litres and are originally used for the maturation of fortified Wines. The 700l port pipe is the largest, the 500l puncheon the smallest of the three. While the port pipe is long and slim, the puncheon is shorter and bulkier than the Sherry butt. All three are made from European as well as from American oak. The cask sizes are not fixed but rather approximate figures.
- The second cask type is the Bourbon barrel. Bourbon matures in charred American oak casks (American Standard Barrel - ASB). They hold approximately 55 American gallons or 200-210 litres (1 Gal- = 3.78l). Read about the Bourbon barrel production at here.
- The third cask type is the hogshead. There are two sub-types: The Sherry hogshead made from old Sherry casks, and the ASB-turned-hogshead. The latter is built by reassembling an ASB and adding more staves and new hoops to increase the capacity to 250 litres. Out of four ASBs you can make three hogsheads.
2. Effect on the Spirit
During maturation chemical reactions take place between the alcohol, the aromatic substances and the wood. These reactions increase the amount of esters and aldehydes in the . Beside the Sherry or remainders in the barrel wall, the alcohol also extracts tannins, vanillin and caramel from the wood. The contact of the Whisky with the wood of the cask wall is therefore essential. Due to its larger volume (250l), only 75% of the cask wall of a has contact with the Whisky compared to a smaller barrel (158l). With a Sherry (500l) it is even only 50% of the surface. Distilleries with a high output usually use smaller , since the Whisky matures faster in these cask types.
3. Rejuvenation of the Casks
After a cask has been used for maturation several times, its maturation abilities decrease, since the wood is exhausted. However, to a limited extent these casks can be rejuvenated by removing the old inner charcoal layer and the inside again. This procedure releases the vanillin and caramel taste in the wood again. In the past a sweet, boiled liquid made from grapes (Paxarette) was pressed with high pressure into the cask walls in order to give the a Sherry character again. However, this method has been discredited and hasn't been used for quite some time now.
Translated to the price of the Whisky that matured in a , the barrel amounts to costs of 5 cents per 0.7l bottle of 10-year-old Single Malt Whisky (if the barrel was used three times).
4. Angel's Share
https://www.whisky.com/During maturation, the alcohol/ mixture of the warms up and expands in the warm summer months, while in the cold winter months it contracts again, thereby "breathing" the surrounding air through the pores of the oak wood. This becomes especially apparent on Islay, where the sea air affects the taste of the Whisky. Usually the Whisky loses between 0.5% and 1% of its alcoholic strength per year during . The Scots call this the Angels' Share, since it evaporates irretrievably into the sky. But beside the alcohol also a portion of the water in the Whisky evaporates. The loss of liquid is therefore significantly higher than the loss of alcohol (up to 2% per year). Since alcohol has a higher vapour pressure than water at the same temperature, (almost) always more alcohol evaporates than water, and the in the cask decreases.
But there are rare exceptions from this rule. Maturation in a dry and hot environment leads to an intensified of the water content of the Whisky. Close to the roof of new, tall it can get so hot that the alcohol content of the rises to 66%-67% during maturation. The rise of the alcohol content leads to different reactions with the wood and the production of different flavours. Most Scottish distilleries fill their Whisky into the with an alcohol content of 63.5%, since that's a reasonable compromise between short maturation time and alcohol evaporation.